Transfer punch set - 28 piece

Transfer punches are ideal for disassembling pens. Choose the size that best fits inside the pen barrel or pen cap, so that it engages on the part you want to remove, then use a hammer on the end of the punch to knock out the component.

This transfer punch set comprises 28 pieces, from 3/32" - 17/32" (2.4-13.4mm). Each punch is 125mm long, and the set comes complete with a storage base. For ease of reference, each hole in the base is marked with the size of the punch.

Make sure you have a secure hold on the pen before you start hitting with a hammer - our soft-jaw locking grips are ideal for the purpose, or they can be used to supplement the knockout rods supplied with our pen assembly/dis-assembly press, to make it even more versatile.

Transfer punches can also be used in conjuction with a magnetic v-block and a disk sander to provide a useful way of trimming glued-up pen blanks in preparation for turning on the lathe.

Select a transfer punch of a suitable size to go inside the pen tube, and with the v-block held firmly at right-angles to the sanding dick by means of the powerful on/off electro magnet, place the transfer punch in the V of the block to allow the blank to be slid forward on the punch and offered up to the rotating sanding disk.